Drain and Waste Pipe Repair in Whitby
Cracked ABS, rotted cast iron and leaking drain joints cause slow drains, smells and stains. Repairs depend on the pipe material and where it sits.
- Drain and Waste Pipe Repair handled by a licensed plumber
- Cause found and shown to you before any repair
- Price explained before work starts
- Tested, cleaned up and written down when finished
- Licensed plumbing trade
- Camera before digging
- Written job notes
- Phone-only booking
Signs, filed under symptoms
- Stains below a drain
- Sewer smell in a wall
- Visible cracks in a cast-iron stack
- Wet basement ceiling after a shower upstairs
How the job is handled
We locate the failed section and replace it with matching or compatible pipe, using approved transition couplings between cast iron and plastic. Vertical stacks need support above and below the cut before anything is removed.
ABS plastic drains can crack from impact or poor support. Joints can separate if the pipe was not glued properly. Cast iron rusts from the inside, sometimes leaving a thin shell that cracks during unrelated work.
When we replace a section of stack, we support the pipe above and below the cut so the weight does not shift.
Signs you need this work
- Sewer smell from a wall or ceiling
- Drip from a drain pipe in the basement ceiling
- Rust stains on a cast-iron stack
- Water stain under a tub or shower
What the plumber brings
Tools and parts that come in from the truck for this kind of call, so the fix can usually be made on the first visit:
- No-hub couplings and snap cutter
- ABS and PVC fittings
- Riser clamps
- Camera for inside the pipe
The job, step by step
- 01
The drip or smell is traced to the exact section
- 02
The pipe is supported above and below the cut
- 03
The bad section is cut out
- 04
A new section is coupled in
- 05
Fixtures are run and every joint is checked dry
Symptom, cause and fix
| What you see | Usual cause | What we do |
|---|---|---|
| Cast iron cracked | Rust through the wall | Cut out and couple in new pipe |
| ABS joint leaking | Failed glue joint | Cut and re-glue the fitting |
| Smell, no leak | Dried-out trap or failed vent | Prime trap, check vent |
Local card: Whitby houses
Older Whitby homes often have cast-iron stacks that rust from the inside out. A section can look fine outside and be thin within.
The visit, in order
- Leak located
- Section supported and cut out
- New pipe and couplings installed
- Drain tested
Ring us when
Call when you see staining or smell sewer gas.
Common questions
Can cast iron be partly replaced?
Yes, with proper couplings.
Why does my stack smell?
A crack or failed joint can let sewer gas escape.